Bobby,
You need to setup Drill Pairs in Setup > Drill Pairs where you indicate beginning and end layer. Make sure you also create partial vias corresponding to the Drill Pairs
Regards, Y
an
↧
Channel:
Mentor Graphics Communities: Message List
X
Are you the publisher?
Claim or
contact us
about this channel.
X
0
Channel Details:
- Title: Mentor Graphics Communities: Message List
- Channel Number: 26396400
- Language: English
- Registered On: December 6, 2013, 6:01 pm
- Number of Articles: 4541
- Latest Snapshot: October 12, 2016, 7:51 pm
- RSS URL: http://communities.mentor.com/mgcx/community/feeds/messages?community=2005
- Publisher: https://communities.mentor.com/?view=discussions
- Description: Most recent forum messages
- Catalog: //verification307.rssing.com/catalog.php?indx=26396400
© 2025 //www.rssing.com