Hello,
When trying to use the "Area Cut Trace" command the job locks up. In the lower tab it states that the command is processing but it just sits there @ 0%. I eventually have to just manually crash the job. Is anyone else having this issue? I'm using X-ENTP VX.1.1. I'm not sure if it matters, but I do have the older versions of software installed on the same computer. (Ex:7.9.1, 7.9.2, 7.9.4 and 7.9.5). Any feedback would be greatly appreciated.
Randall Bennett
Sr. PCB Designer
Palpilot International(512) 731-3759