Thanks for the fast response!
But this will not solve my problem. We are using xDX Databook and get the parts by drag-and-drop from there.
With the central library we are only getting one symbol for one part.
Because if I try to map the gates by editing the part in the central library I get a error gate-(x) is using 2/16 pins.
And I didn't find a way to define a decal pin to more than one gate:
So we could assign only 16 single resistor symbols OR one symbol with 16 pins for this part:
But in netlist mode we where using this feature very often.
Sometimes a resistor array is used a "general" pull up at one place in the schematic.
Sometimes it was used as single resistors placed somewhere in the schematic.