Hello Pat
thanks for your help. I tried to sum up the information about where the Connector ends and starts in one column (shown in the image).
How can I define a new attribute ? or it is possible to edit the given columns (can only change the name)?
Regards,
Ju
Von: Pat
Gesendet: Donnerstag, 1. Oktober 2015 06:32
An: Julian Eberl
Betreff: Re: - How to edit the wire table in Vesys 2.0?
Mentor Graphics Communities <http://jiveon.jivesoftware.com/mpss/c/mwA/PDcDAA/t.1qw/XZoW0cK0Q5ekoSbJzPoiww/h0/eqhG5v9o4WV1pCmWaB03cSwwDs9TlgB0xbMVIWwm646GILn2bw-2Ff2VvpCMWbuWme4I7kQJipkGwU98P5sepQgQ-3D-3D>
How to edit the wire table in Vesys 2.0?
reply from Pat<http://jiveon.jivesoftware.com/mpss/c/mwA/PDcDAA/t.1qw/XZoW0cK0Q5ekoSbJzPoiww/h1/eqhG5v9o4WV1pCmWaB03cQPonHs-2F4hxrsuPaqzmJxzFtfpCUKVPVFQQwO6ZDxgIAlzf7PS3-2FFkuNXCF56ggW59nFIhTGEGkfV75lVFI7yK0-3D> in Electrical System Design and Harness Engineering - View the full discussion<http://jiveon.jivesoftware.com/mpss/c/mwA/PDcDAA/t.1qw/XZoW0cK0Q5ekoSbJzPoiww/h2/eqhG5v9o4WV1pCmWaB03ccOzRWqU8C3oWKaxtwDa6yshYH8PRdZ9TxxsGrLA-2BRv-2BoiHgHH1-2BUCme0HrUodwq8YGzqP-2FoCqFjP8cYC7Bpc4M-3D>