Hi David,
I almost have everything to finish the board.
I was able to configure the spreadsheet. I had to in PADS Layout set High-Speed roules for my + and - signal from differential pair.
I can now see in Net Length Monitor estimated and routed length (not sure why there are both). My previous question with the
accordion works great and I am able be using Interactive Route to add it.
Another two questions:
1. I can change one signal, how to switch into differential pair mode and add lenght to both signals ?
2. For measuring the length of traces out of the connector with the added accordion I would like to use QL command.
So I could see how good they are matched after the connector to some point close to it (i.e. next turn or trace split?). How to do it in PADS Router.
I of course considered using the whole routed lenght, however let's assume that I have the same issue on the other side, so I couldn't say that I'm matching difference both from this side of the connector and the other one.
Best,
Pawel