Re: Different width/gap on the same layer for Differential Pair

Hi David,

Thanks for clarifying, so I simply have to create a component with two pins and decal that is related to my wider width/gap.

Then in my schematic I have to put it and connect it to my differential pair, and then use pin-pair rules to change width/etc. in layout/router

Will it still route me my differetnial pair together ? I can't check at the moment.

Also another differential pair question.

I would like to length match my other differentia pair (not the issue with different gap/width) in a matter as on the above image.

So when i routed out of the connector I would like to add small accordion to shorter trace to make them equal at that point (to match positive signal

with negative).

Is it possible with pads ?

Best,

Pawel