Re: Part alignment options in xPCB
Hi,Thank you for the help. But how can I make an array of equally spaced resisters (let's say 9x9) like a square ? Thank you
View ArticleRemove automatic tuning of traces
Hi all, I am trying to design a high speed PCB with several differential lines. I used "Plow" tool to manually draw the traces of these differential nets. But xPCB tunes the traces automatically which...
View ArticleRe: Setup Templates for constraints reuse
Hi, is it possible to decrypt the exported .cts file and edit it for further changes? Praveen
View ArticleRe: Part alignment options in xPCB
In Radial Array dialog select an icon you need and setup its parameters and priced. You can also refer to Help or you can call Customer Supprt. Regards, Yan
View ArticleClik here to view.
Re: Remove automatic tuning of traces
In your Editor Control > Route tab > Tuning Patterns dialog... Set the Interactive Urgency to Off. Thanks,Vern
View ArticleRe: Part alignment options in xPCB
At this time, there is no Rectangular Array Placement command in Xpedition VX.1 Thanks,Vern
View ArticleClik here to view.
Re: Importing DXF
With your design open, select File>Import>DXF, choose the file you want, and in the next dialog box, select the Add radio button. It defaults to New.
View ArticleClik here to view.
Re: Can't add thermal connection to VIA. Stays flooded over.
Hi, Please ensure that thermal plane net name and via net name both are same. If it is same then i think that the spoke width you have entered in the plane class and parameters tab is so high than the...
View ArticleRe: Loss of relationship between differential pairs
Do you have the High Speed Design Option (HSR) enabled? (or using pinnacle which automatically recieves an HSR license)Setup > Licensed Modules > High Speed (HSR).
View ArticleDFF errror
I have a plane that when I run verification on gives me errors on the 90 degree corners of every rectangular cutout on it.The error is:"DFF Error:Sliver on Power Inner Layer 3" I have attached a...
View ArticleClik here to view.
VeSys Dressed Connectors
I'm trying to use a dressed connector for the connector shown above. But I cannot seem to set different routes for each section of cavities. I'm working in VeSys Harness. Is it possible to do this?...
View ArticleRe: Can't add thermal connection to VIA. Stays flooded over.
Where do i find the Plane Class and Parameters Tab?
View ArticleClik here to view.
Re: DFF errror
That seems odd - why would rectangles cause slivers? Slivers Flags copper sliver and solder mask sliver areas. This compares the top solder mask layer against the top electrical layer and the...
View ArticleRe: Importing DXF
I'd be surprised if it was the version, but I can't rule it out. I import enough DXF files that I bought AutoCAD LT to do the heavy lifting, and I always save the files as Release 12, which is the...
View ArticleLibrary Manager and Property Definition Editor
Hi, I'm new to xDX Designer and I'm currently following "Xpedition Evaluation Guide" to be familiar with Xpedition Entreprise. On its 70th page, I have to access "Tools > Library Manager" and "Tools...
View ArticleRe: Library Manager and Property Definition Editor
Thanks for catching this. We will update it. Try Tools > xDM Library Tools. You will find the Property Definition Editor there. Thanks , Vern Wnek
View ArticleRe: Can't add thermal connection to VIA. Stays flooded over.
Hi, I am using Expedition PCB 7.9.4. I thing you are using some other tool and I'm not proficient in other tools. But I am sure that, your spoke width is high than the padstack value. So only it is...
View Article