I just translated a DC schematic to xDx with the VX.1.1. translator.
Some of my resistors are disconnected at one side and they look smaller and are off-grid.
These resistors are related to a "CPA_CPU" partition which the translator created.
This is not a partition which I have normally in my Library.
I can not run forward annotation in xPCB because the used part number is not in the "CPA_CPU" partition.
The errors show up in the PartPkg.log file.
To solve the problem I have to replace the symbols / part numbers with ones from my own library.
Does anybody have seen this also with a DC to xDX translation?
Thanks,
Wim.