Hello Friends,
You need to define a spécial PADS STACK for the pin you want to connect/not connect on a spécific layer.
- edit the part decal:
1-ADD the pin concernedin the pin list (B13 in the example)
2-ADD the layer concerned(Layer 3 in the example)
3-SPOKE = 0
(spoke angle=0)
4-SPOKE WITH = any positive value. ex:1
As a result you should see ,as images show,pin B13 connected to plane P5V (magenta) on inner layer 2 beside GND (green)plane on the same level.
On the second example you should see pin B13 NOT-connected to an new plane P5V présent on Layer 3 beside P15V (bleu)
I'do not have problems with that configuration in may jobs.
Have a good day/Bonne jounée.
Vincent.