I created a splice with following settings:
The splice is placed in integrator plane. To the splice I connected 4 wires:
where 4008A is set intentionally to be 4mm2 (not according to the previously defined Splice Attributes)
I run the four existing DRCs for splices in Integrator but does not show any mistake. Does anyone has more detailed information how these DRCs are working is practice?
Existing Integrator DRCs for a splice with Info Hub descriptions are listed below:
- Two-wire splice - Inefficient splice situations where a splice connects just two wires.
- Minimum splice separation rule violation - Identifies splices that violate any applicable minimum separation constraints (rules). Also reports the bundle and harness on which the violation exists.
- Splice that breaks number of wires rule - Identifies splices that violate any applicable maximum number of wires per splice constraints (rules). Also reports the bundle and harness on which the violation exists.
- Splice that breaks specification rule - Identifies splices that violate any applicable splice specification constraints (rules). Also reports the signal and harness on which the violation exists. And any conflicting splice specification constraints (rules) that apply to the design.
Does anything in Capital could point such incompatibility between splice and wire which is connected to it?
Appreciate for any help and tips.
Best regards,
Adam