Hello all,
I'm new to this forum. I started working with CHS about 3 months ago and I just started working with Capital Integrator. I have one question already though:
I'm importing the XML files from the harnesses that I need to add to the integrator plane. These XML files I've exported from Creo Parametric 2.0. In Parametric, I designate the connectors as "XDEV" being "DEV" the device name from Capital Logic. So when I import the XML into the Integrator plane, the slots that generate automatically have the same name as the connector itself "XDEV". So, before being able to autoplace the devices, I need to delete the X in "XDEV" so the device name will match the slot's.
I can do this by hand, it's not much of a problem. But I was wondering if there's a better way to do it, because if I have a lot of connectors/devices, this is going to take some time and a lot of patience.
Thanks in advance for your help, any input on this is much appreciated.
Cesar Triana