Quantcast
Channel: Mentor Graphics Communities: Message List
Viewing all articles
Browse latest Browse all 4541

Re: Busbar styling

$
0
0

Perhaps my Post was not clear but Example 1 was in regards to the fact that it appears the parameters are always.  Expecting certain decoration.  Perhaps this example will be a little more clear.  Lay down a generic device that is 5 pin grids wide.  Select it right click> properties and go to the parameters tab.  Under Param: top remove corner-TL, corner-TR and two of the decoration so that you are left with the following:
Param-top.png

In Logic the device is updated to look like this

Pin-TL-TR.png

Note it treats the corners as if they are blanked, and does not create a hline graphic at the corners, even though Corner-TL and Corner-TR are not in the parameters.  When this same device is resize to be 1 pin grid (i.e. only corners exist), the hline is not displayed at all.  This is why I asked Question 3, is there anything that defines what a parameter is required to have.  If the tool is expecting a top to always have corners, then it will affect if we can use 1 pin grid wide devices, as well as how we build the glyphs. 


Viewing all articles
Browse latest Browse all 4541

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>