Hi David,
Thanks for the reply.
I am mostly using Altium at my work, and doing such thing in Altium in design rules is as simple as breathing.
I'm struggling with PADS, about which I had a rather good opinion (thanks to hyperlynx and auto router) but as I have to do some simply tasks,
routes, almost anything this software sucks. I have been using mentor support, reading all comments, forums, etc and it always in PADS comes to such solutions.
My differential pair must basically have different width/gap coming out of the connector pins (pins located inside some other pins of the connector). Maybe it could be possible to place pads of the "component" inside there, however I don't know now. Perhaps I could remove those pins from the connector footprint and put them on the "component" so the connector footprint wouldn't change and also in the "component" put pads for wider differential pair outside a connector. But this solution horrifies me as I have multiple differential pairs...
Thank you once again for the reply. I am afraid that I don't understand the statement about unroutes in the correct order and reschedule command.
Best,
Pawel
